Thin cylinder

Product features:Stainless steel

Type:Thin cylinder

Action mode: impact gas

Cylinder diameter:0.58mm

Standard stroke:3.55mm

Number of cylinders:12

Theoretical force:21N

Pipe diameter:1.2mm

Temperature range:0-35 degrees

Applicable pressure:1500

Pipe thread: deep grain

Speed range:100

Specification:Conventional

The push and pull force of the piston rod is determined by the force required to do the job. Therefore, in the choice of cylinder, should give the cylinder output a certain amount of leeway. If you choose the bore is too small, the output power is not enough, the cylinder can not work properly; However, because the bore of the finger cylinder assembly is too large, not only the equipment is bulky, high cost, and the consumption of gas will also increase, thus leading to a waste of energy. In order to reduce the volume of the cylinder, in the fixture design to use as much as possible to increase the force mechanism.

①Single-action cylinder: Only one piston rod is provided at one end, and its side is made of air gathered from the air. Under pressure, the piston will push outward a kind of thrust, and then rely on spring or gravity to pull it back.

②Double-action cylinder: The air is supplied by both sides of the piston in turn, so that it is output along one side or two sides.

③Diaphragm type cylinder: using a spacer instead of a piston, outputting force in one direction only and resetting it with a spring. With good sealing, but the stroke is shorter.

④Magnetic coupling rodless cylinder it is a component. This device converts the pressure energy of compressed gas into kinetic energy of the piston (10-20 m per second) and uses it as power. The impact cylinder joins a middle cover, which has a nozzle and a venting hole. The middle cover and the piston divide the cylinder into three chambers: the storage chamber, the head chamber and the tail chamber. It is suitable for undercutting, punching, crushing and forming. Reciprocating cylinder called swing cylinder, through the blade to the cylinder into two parts, so that the air in the two cavities between the alternating supply, so that the output shaft in about 280 ° swing. In addition, there are rotary cylinder, gas-hydraulic damping cylinder, stepper cylinder, etc.